CITROEN XANTIA User Manual

PRIVATE CARS
XANTIA-XM-SYNERGIE
PRIVATE CARS
CAR 050008
Book 2
2001
AC.QCAV/MTD
Méthodes Techniques Documentation
 ’’The intellectual property rights relating to the technical information contained in this document belong
exclusively to the manufacturer. Reproduction, translation or distribution in whole or in part without
prior written authorisation from the manufacturer is forbidden.‘‘
«The technical information contained in this document is intended for the exclusive use of the trained personnel of the
motor vehicle repair trade. In some instances, this information could concern the security and safety of the vehicle. The
information is to be used by the professional vehicle repairers for whom it is intended and they alone would assume full
responsibility to the exclusion of that of the manufacturer».
’’The technical information appearing in this brochure is subject to updating as the characteristics of each
model in the range evolve. Motor vehicle repairers are invited to contact the CITROËN network periodically
for further information and to obtain any possible updates».
2001

CITROEN XANTIA Specifications

General

Brand	CITROEN
Model	XANTIA
Category	Automobile
Language	English

Summary

PRESENTATION

IMPORTANT

IDENTIFICATION OF VEHICLES XANTIA - All Types

IDENTIFICATION OF VEHICLES XM - All Types

IDENTIFICATION OF VEHICLES SYNERGIE - All Types

CAPACITIES

Draining method.

Describes the procedure for draining fluids.

LUBRICANTS - TOTAL recommended oils

ENGINE SPECIFICATIONS

XANTIA - XM SPECIAL FEATURES - TIGHTENING TORQUES

CHECKING AND SETTING THE VALVE TIMING

TOOLS

Lists necessary tools for valve timing procedures.

CHECKS

Outlines checks to perform before setting valve timing.

SETTING THE VALVE TIMING

Details the process of setting valve timing for various engines.

CHECKING AND SETTING THE VALVE TIMING

TOOLS

Lists necessary tools for valve timing procedures.

CHECKING THE VALVE TIMING

Outlines checks to perform before setting valve timing.

SETTING THE VALVE TIMING

Details the process of setting valve timing for various engines.

Preparation

Steps to prepare for setting valve timing.

PROHIBITED OPERATIONS: HDI DIRECT INJECTION SYSTEM

Cleaning

Procedures for cleaning HDI direct injection system components.

Fuel supply circuit

Information regarding the fuel supply circuit for HDI systems.

Electric circuit

Warnings about electrical connections in HDI systems.

High pressure fuel pump

Specific components of the high pressure fuel pump.

CHECKS : LOW PRESSURE FUEL SUPPLY CIRCUIT

CHECKS : TURBO PRESSURE

SPARKING PLUGS

CLUTCH SPECIFICATIONS

CLUTCH : CHECKS AND ADJUSTMENTS

GEARBOX AND TYRE SPECIFICATIONS XANTIA

BE3/5 GEARBOX

4 HP 18 AUTOMATIC GEARBOX

AL 4 AUTOMATIC GEARBOX

4 HP 20 AUTOMATIC GEARBOX

TRANSMISSION - GEARBOX

AXLE GEOMETRY XANTIA

SUSPENSION XANTIA

STEERING XANTIA

AXLE GEOMETRY XM

SUSPENSION XM

STEERING

AXLE GEOMETRY SYNERGIE

BRAKE SPECIFICATIONS XANTIA

BLEEDING THE BRAKES XANTIA

DE-PRESSURISING THE SUSPENSION CIRCUITS

FILLING AND BLEEDING THE SUSPENSION CIRCUITS (continued)

PNEUMATIC UNITS – DAMPERS XANTIA

STARTER MOTORS XANTIA

ALTERNATORS

CHARGING CIRCUIT - ALTERNATOR WITH MONO-FUNCTION REGULATOR

PRE-HEATING AND STARTING SYSTEMS

AIR CONDITIONING R 134 a (HFC)

SPECIAL FEATURES : AIR CONDITIONING SYSTEM (R 134.a)

CHECKING THE EFFICIENCY OF THE AIR CONDITIONING SYSTEM