10
AX4000G
Actuator
Safety precautions
Refer to the safety precautions on Intro 13 to 20 before operating.
F
F
L
(Note) Moment load
M (N·m) = F (N) x L (m)
M: Moment load
F: Load
L: Distance from center of output shaft
M (N·m) = F (N) x (L + 0.02) (m)
M: Moment load
F: Load
L: Distance from output shaft flange surface
(Fig. a) (Fig. b)
L
Use the noise filter for the motor cable if the cable is longer than 6 m.
When connecting the motor cable and driver, check that the cable's mark tubes and driver's indications are correct.
Use the optional flexible cable in applications where the cable is bent repeatedly.
When using a flexible cable, fix the cable sheath near the actuator connector.
When connecting the cable, firmly insert the connector to the back. Firmly tighten the connector's set screws and fixing
screws.
Do not modify the cable by cutting or extending it. Failure to observe this could result in faults or malfunction.
When the flexible cable option is selected, flexible cable specifications apply between the driver and actuator connector.
Standard cable specifications apply between the actuator and connector. Fix the cable so that it does not move.
(Only AX4009G)
Do not pull the outlet cable of the device. (Only AX4009G)
AX4000G Series
Safety precautions
To Next Page
Loading...
