CKD ABSODEX AX1022 - AX4000 G Series Ordering (GH Driver); AX4000 G Model Selection Guide (GH Driver)

16
AX4000G Series
How to order
AX4000G
Model no.
Model Model no. of options
Size
(max. torque)
A
Driver type
B
Cable change
Note 2
D
Mounting base
Note 3, Note 4
C
Dowel hole
Note 4, Note 6
G
Brake
Note 5
E
How to order
AX4
A
Size (max. torque)
Symbol Descriptions
150
300
500
150 N·m
300 N·m
500 N·m
B
Driver type
GH With GH type driver
C
Mounting base (cannot be used with dowel holes P2 and P3)
Blank
B
BS
Standard (without mounting base)
With blackening mounting base
Electroless nickel plating, surface treatment mounting base
Use with body surface treatment S.
D
Cable change
Blank
D**
DM**
Standard (cable length 4 m)
Cable length change
Flexible cable length change
Option table
Electromagnetic brake (-EB)
E
Brake
Blank
EB
Standard (without electromagnetic brake)
With negative actuation type electromagnetic brake
300 DM08 EBBSGH
Body surface treatment
Note 3
H
P1 S
Note on model no. selection
Note 1: Select the driver according to the table below.
Driver - power voltage table
* Contact CKD when ordering parts individually for maintenance.
Note 6: Additionally machined sections may not have a treated surface.
Model
Driver
type
GH type driver
3 phases
200 to 230 VAC
AX4150G
AX4300G
AX4500G
Blank
Blank
Blank
**cable length
02
Blank
06
08
10
15
20
2 m
4 m
6 m
8 m
10 m
15 m
20 m
Flexible cable 4 m: DM
AX4150G AX4300G AX4500G
G
Dowel hole
Blank
P1
P2
P3
Standard (without dowel hole)
1 on top
1 on bottom
1 each on both top and bottom
H
Body surface treatment
Blank
S
Standard (rotational section - blackening,
fixing section casting surface plane - paint)
Rotational section: electroless nickel
plating treatment, fixing section: nitriding
F
CE marking
Blank
K
Standard (CE marking not available)
CE marking
K
CE marking
F
[Note]
Use the noise filter for the
motor cable if the cable is
longer than 6 m.
Note 2: Use the optional flexible cable in applications where the cable is bent repeatedly.
Refer to page 17 for the cable dimensions.
Note 3:
Designate body surface treatment and mounting base surface treatment with (C) and (H).
Note 4: "P2" and "P3" cannot be selected if "B" with blackening mounting base or
"BS"electroless nickel plating surface treatment mounting base is designated for
(C) mounting base.
Note 5: Refer to the Option Table below and select required options.
Actuator