CKD ABSODEX AX1022 - AX-OPX Slave Unit Installation Guide; GS;S Type Driver Slave Unit Installation; GS;S Type Driver Installation Dimensions; Installation Cautions

70
AX-OPX Series
How to install
Serial transmission slave unit
CC-Link/DeviceNet
The slave's depth is 68 mm, and the plug’s depth is 16.5
mm. The slave is removed with the plug wired.
Fix the slave onto the driver with fixing screws.
Installing the GS and S type driver
Installation dimensions (for GS/S type driver)
Cautions for installation
Slave unit installation (for GS/S type driver)
0V
Slave unit power
24V
S
L
D
F
G
D
A
D
G
R
D
R
U
N
L
D
B
P
W
S
D
E
R
R
L
Installation
Dismounting
I/O connector (AX CN3)
Slave unit set screw
Connect the direct drive ac-
tuator driver's I/O connector
(AX CN3) to the slave, then
tighten slave fixing screws.
160.5 (210)
68
16.5
AX-OPX-7G
AX-OPX-7D
Plug
Set screw
GS/S type driver
Note: Dimensions shown in ( ) are for GH/H type driver.