MOON QUICK START GUIDE
1. Turning the Moon on
a. The Moon can operate plugged into an outlet, using batteries, or both.
b. To insert batteries, open the battery pack using a screwdriver, and place 3 new (AA) batteries.
c. Make sure to always firmly press the buttons to ensure proper function.
2. Setting the clock and wake up times
a. Press and hold the set button for up to 5 seconds to display the Settings Menu. The menu can be navigated
using the “UP” and “DOWN” buttons. Highlighted options can be selected by pressing the “SET” button again.
b. Select the “SET TIMES” option.
c. Select the “CLOCK” option.
d. Select the “AM/PM 24H” option.
e. Select whether you would like to clock to use a AM/PM cycle or a 24H cycle, and press the “SET” button to
confirm.
f. Highlight the hours, and press “SET” to set the hours, using “UP” and “DOWN” buttons. Press set again to finish
setting hours.
g. Repeat step f. with minutes.
h. Highlight the option to return to the previous screen.
i. To set the time at which you would like your child to wake up in the morning during the week, select
“WAKE UP 1W” and repeat steps f. through h. To set the time at which you would like your child to wake up from
their nap during the week, select “WAKE UP 2NAP” and repeat steps f. through h. To set the time at which you
would like your child to wake up during the weekend (see 3b below), select “WAKE UP 3WE” and repeat steps f.
through h.
3. Bedtime
a. Make sure to reset the Moon by setting the Main Switch to O.
b. Make sure that the “W./W.E.” Switch is set to W. during the week, and W.E. during the weekend.
c. When your child goes to bed, set the Main Switch to I.
At that time, the rabbit
will always light up in the
sleeping position, and
the LCD will show the
moon. Ten minutes before
the next set wake up time,
the moon will begin setting
on the LCD to let your child
know that it’s nearly time to
wake up. This is called the
“Wake up Process.”
When it is time to wake
up, the sun will rise, and
the light will change
to the waking rabbit.
d. Upon waking up, you
may switch off the light by
setting the Main Switch
to O in order to save
energy
To Next Page
Need help?
General
