Use
20
6.4.
Nitrogen production
When the generator ends the preparation phase (par. 6.3.) and the message
GENERATOR READY
appears on the display, you can start Nitrogen produc-
tion in the following way.
Push the operative button START/STOP.
The productive cycle is started and the following message appears:
PRODUCTION
6.5.
Stop the generator
The generator can be stopped any time during production, just by pressing the
START/STOP key.
The following message appears during depressurization, that usually lasts 30-60
seconds:
PLEASE WAIT
DEPRESSURIZATION IN PROGRESS
e
PLEASE NOTE: the START/STOP key is not operative during a block of produc-
tion..
The following message appears at the end of pressurization:
GENERATOR READY
At this time, you have two alternatives:
1. to switch off the generator turning OFF the POWER switch (see par. 6.6.)
2. to start again production pushing the START/STOP key (see par. 6.4.)
6.6.
Switching off the generator
6.6.1.
Correct switch off
The correct switch off of the the generator must be started from the
GENERA-
TOR READY
status. The par. 6.5. describes how to reach this condition.
Turn the “POWER” switch OFF to switch off the generator .
6.6.2.
Incorrect switch off
Please avoid of switching off the generator directly without doing the stop ope-
ration described in par. 6.5.
To Next Page
Loading...
