Clair de Lune Bedside Crib - Assembly of Legs D and E; Assembly of Rods a and B

2
D
1
2mm Nuts
x2
E
Once you have the correct height setting assemble both sets of legs D and E using the 40mm
bolts and 12mm nuts. Place leg E flat on the floor then place leg D on top and line up the
correct hole position according to the height setting for your bed (from back page).
40mm Bolts
x2
3
Assemble Rods A and B as below using 8 x Long Bolts.
!
Note that part D has
additional holes
Long Bolt
x1
Long Bolt
x1
Long Bolt
x1
Long Bolt
x1
Long
Bolt x1
Long
Bolt x1
Long Bolt
x1
Long Bolt
x1
A
Longer
Rod
B
Shorter Rod
A
Longer
Rod
B
Shorter
Rod
Ensure that
assembled legs are
the correct way up
and face inwards.
(note the position of
the additional holes)
It will seem like the shorter Rods are
not long enough, this is normal and
requires slight compressing of the
assembled legs together. Once fully
assembled the stand will naturally
taper inwards towards the top.
!
3
L
eg D must be on
top of leg E with
the additional
h
oles facing up.
!
Shorter rods B
must be at the
top.
!