Clara S Series - User Manual

32 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

Guide

d’installation et

programmation

S-Line

- ENGLISH WILL FOLLOW ON PAGE 17 -

Questions and Answers

S
shelby79Aug 1, 2025
Why is my Clara Indoor Furnishing motor not responding?
- S
  ssullivanAug 1, 2025
  The Clara Indoor Furnishing motor might not be responding due to several reasons. The batteries may be depleted, so replace them with new AA alkaline batteries. Ensure the batteries are correctly inserted with the proper polarity. Also, check that the motor is properly connected to a power source. Radio interference could be a factor; ensure the transmitter is positioned away from the motor and not in contact with metal. If the transmitter is too far from the motor, move it closer. Verify the power supply to the motor is connected and active. Incorrect wiring can also cause this issue; ensure all wires are correctly connected, referring to the installation instructions.

Summary

INSTALLATION OF YOUR SHADE

Component Overview

Lists shade components and required tools for installation.

Install

Instructions for mounting shade brackets in various configurations.

QUICK PROGRAMMING

Set limits

Guides on setting the shade motor's upper and lower travel limits.

ADVANCED PROGRAMMING

Motor state test

Explains P1 button functions based on motor programming state.

Motor configuration options

Details pairing, sleep mode, direction reversal, and motor reset procedures.

Pair motor with controller

Step-by-step process to connect the motor and remote control.

Check motor direction

Verifies and reverses the motor's travel direction.

ADJUSTING LIMITS

Adjust upper limit

Procedure to set the shade's highest desired position.

Adjust lower limit

Procedure to set the shade's lowest desired position.

ADDING OR REMOVING CONTROLLERS AND CHANNELS

Using motor P1 button

How to add/remove motors using the P1 button on the motor head.

Using a pre-existing controller

Steps to add or retain an existing controller or channel.

FAVORITE POSITIONING

Set a favorite position

Instructions to save a specific shade position.

Send shade to favorite position

Commands the shade to move to its saved favorite position.

Delete favorite position

Steps to remove a saved favorite position.

ADJUSTING MOTOR SPEED

Increase or decrease motor speed

Guide to adjust motor speed across three levels.

HOW TO CORRECTLY CHARGE YOUR MOTOR

TROUBLESHOOTING

Clara S Series Specifications

General

Brand	Clara
Model	S Series
Category	Indoor Furnishing
Language	English