Clarion
PSWGMTK
Behind
Seat
Mount
Camouflage Powered
Subwoofer
Chevrolet S-10 I Chevrolet
Full
Size Pick-up Truck
Fits '95 - 2000 Chevrolet S-10
and
GMC Sonoma
'95 - '98 Chevrolet
Full
Size Pick-up Trucks (extended cab only)
PREPARATION '
PARTS
LIST
(QTY) Component
Pre-Assembled
(1) Roto-Molded Subwoofer Enclosure
(1) 8", 2 Ohm Subwoofer
(1)
100W
Class
"0"
Amplifier
(1) Speaker Grills
(1) Foam Ring for Grille
LooseParls
(1) 17' Wire Harness w/Pigtail Style Connector
(2) Mounting Brackets
(4) 3/4" Pilot Point Wafer Phillips Head Screws
(4) 1" Self-Tapping Phillips Head Screws
(1) 1/2" Ground Screw
(1) Star
Washer
Wiring:
1 Green
2 Violet/Black
3 Green/Black
4 Violet
5 Blank
6 Black
7 BluelWhite
8 Yellow
OVERVIEW
The Clarion Camouflage subwoofer system provides for the installation
of
a low frequency driver
in
an enclosure which is
powered by a small low current, high power class
"0"
(Digital) amplifier The advantage to using this type
of
amplifier is
in
the
low current consumption
of
the amplifier at high power levels The class
"0"
amplifier pl\)vided with this system will produce a
rated 100W into a 2 ohm load The woofer supplied with this system uses a voice coil with rated impedance
of
2 ohms, and
therefore is not considered a standard woofer Replacing the woofer with any driver having an ;mpedance greater than 2 ohms
will yield lower power output from the amplifier, and is not recommended
PROCEDURE
Proper installation
of
this
product requires proper
tools
and knowledge
of
car
audio principles
If
you are
not
comfortable performing any
of
the outlined tasks below, contact a professional installation facility
to
perform the work
OUTLINE
• Remove the head unit
- Connect the Clarion "T" harness between the radio and factory wiring and route the harness in the vehicle
• Install mounting brackets onto subwoofer enclosure
- Test subwoofer enclosure and head unit functions (fade, balance,
etc)
- Adjust subwoofer gain
• Install the enclosure
• Re-assemble the vehicle
THIS DEVICE COMPLIES WITH PART
15
OFTHE FCC RULES. OPERATION IS
SUBJECT
TO THE FOLLOWING
TWO CONDITIONS.
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE,
AND
(2) THIS DEVICE MUST ACCEPT
ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY
CAUSE UNDESIRED OPERATION
- 1 -
To Next Page
Need help?
General
