Starting from a Safe Condition 4-7
Section 4. Operating Procedures
Operating Safely
Safe operation is the responsibility of the operator. Watch
where you are going. Don't go if you can't see.
Before driving, check all around to
be sure that your intended path of
travel is clear of obstructions and
pedestrians.
While driving, be alert for
pedestrians, other vehicles or
obstructions in your path of travel.
Watch people. Do not allow
anyone to stand or pass under the load or raised forks. Watch for
people in your work area even if your truck has warning lights or
alarms. They may not watch for you.
Sound horn at intersections and wherever vision is obstructed.
Do not drive a truck up to anyone standing in front of an object.
Protect yourself and those around you...
Operate the truck only from the designated operator's position. Stay
within the confines of the lift truck profile dimensions. Keep arms,
legs and hands inside the operator's compartment and away from
the danger of passing obstructions. Keep under the overhead guard.
An overhead guard is intended to offer protection to the
operator from falling objects, but cannot protect against
every possible impact. Therefore, it should not be consid-
ered a substitute for good judgement and care in loading,
handling, storage, etc..
Keep clear of the upright and lift
mechanism. NEVER reach into or put
hands, arms, legs or head into or through
the upright structure or near the carriage
or lift chains. Never put any part of your
body between the upright and the truck.
Don't use the upright as a ladder.
To Next Page
Loading...
