7
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
2. Remove the filler plug to release
any trapped air, top up the
reservoir with clean hydraulic fluid
and re-insert the plug.
3. Repeat operations 1 and 2
(above) until all air is purged from
the system.
If the above procedure does not
cure the fault contact you local
Clarke dealer.
TO LOWER THE LIFT
As the weight of the table is taken by the Locking Bar, it is necessary to pump
the Foot Lever slightly in order to take the strain and then remove the Locking
Bar.
1. Visually check under and around the lift to ensure that no obstruction will
interfere when lowering the table.
2. Depress the lowering lever until the table is at its lowest position.
3. To manoeuvre the lift around the workshop, screw up the stabilizers to allow
the castors to function. For storage purposes, always screw the stabilizers
down to take the weight off the castors.
To Next Page
