Introduction
1-4
Manual Summary
Chapter 1. Introduction
This chapter includes an overview of the manual and safety information.
Chapter 2. Installation
This chapter describes the hazards and recommended safety practices you should observe when servicing
or operating the Clarus 500 GC.
Chapter 3. Maintenance
This chapter describes how to install the Clarus 500 GC. The Pre-Installation and Installation Checklist
are included in this chapter, as is the Customer Orientation Script.
Chapter 4. Firmware
This chapter describes how to download the firmware on to the Clarus 500 GC.
Chapter 5. Performance Test
This chapter describes how to test the instrument using different detector/ injector configurations.
Chapter 6. Autosampler
This chaper includes descriptions of and service procedures for all autosampler mechanical and electrical
components. Schematics for autosampler electrical components are included in this chapter.
Chapter 7. Diagnostics
This chapter describes how to run the Clarus 500 GC software diagnostics.
Chapter 8. Troubleshooting
This chapter describes how to troubleshoot general instrument problems.
Chapter 9. Electrical System
This chapter includes circuit descriptions of and service procedures for all electrical system components.
Schematics are included in this chapter.
Chapter 10. Hardware System
This chapter describes the components of the Clarus 500 GC mechanical system, which includes
detectors, injectors, pneumatic controls, and the oven.
Chapter 11. Pneumatics
This chapter includes a full range of pneumatics options provides optimum performances with all types of
columns and detectors.
Chapter 12. Service Data Bulletins
This chapter allows you to store your upcoming service data bulletins.
Related User Documentation
For detailed operating instructions beyond what is included in this manual, refer to the Clarus 500 GC
User’s Guide, Part No. 0993-6625A.
To Next Page