Clas Ohlson HK-TF2144A User Manual

5
English
Charging thehelicopter
The helicopter is charged via thecontroller.
1. Open thepanel on theside of
thecontroller and withdraw the
charger lead.
2. The on/off switch on thehelicopter
should be set to OFF.
3. Connect thecharger lead to thehelicopter.
4. Switch thecontroller to ON.
5. The green charging light on thecontroller will come on. Chargingtakes approx.
1 hour. Thehelicopter is fully charged when thecharging light stops shining.
Operation
1. Switch thehelicopter and controller on by setting their on/off switches to ON.
2. The helicopter light will come on and thecontroller’s power indicator will flash red.
3. Place thehelicopter on theground with thetail nearest you.
4. When thehelicopter is synchronised with thecontroller it will shine red.
Hovering up and down
Use thethrottle lever to manoeuvre thehelicopter up and down.
Small, smooth increments only, are required to make thehelicopter fly higher or lower.
Spinning clockwise and anticlockwise
Once thehelicopter is hovering
steadily, push therudder to
theleft to make thehelicopter spin
anticlockwise.
Once thehelicopter is hovering
steadily, push therudder to
theright to make thehelicopter
spin clockwise.

Clas Ohlson HK-TF2144A Specifications

General

Brand	Clas Ohlson
Model	HK-TF2144A
Category	Toy
Language	English