AUTOMATIC WHEEL BALANCER 3D WITH LCD SCREEN
Machine calibration for the MOTO wheel type
The calibration for MOTO wheel type (motorcycle wheels) is completely separated from CAR/SUV wheel type
because in the calibration for MOTO a specic adaptor for motorcycle wheels is used and this slightly the shaft
balancing.
If the calibration for MOTO wheel type has not been done and the user try to spin the wheel for balancing in the
MOTO wheel type mode, the machine will not run and will display an error code ERR 031.
To perform the machine calibration with adaptor for motorcycle wheels, proceed as follows:
To Next Page
Loading...