Clavia ddrumAT - User Manual

How to connect and configure drum pads for initial operation.

Explains the 8-channel/16-voice drum system architecture and sound generation.

Details the internal and SoundPac memory structure and usage.

Describes how kits are stored, settings, and memory capacity.

How to select kits using an optional remote device.

Using a ddrumPerformer for kit selection via MIDI.

Method to select channels by hitting pads during editing.

Method to select channels by pressing buttons during editing.

Step-by-step guide to retuning a snare sound.

Guide to matching the length of three tom sounds.

Procedures for saving altered drumkits to memory.

Method for duplicating existing kits to create variations.

Selects sound samples from internal or SoundPac memory for pads.

Controls the basic pitch of a sound, adjustable in semitones.

Simulates or enhances natural pitch bend after striking.

Controls the duration of pitch bending up or down.

Controls the overall length of the sound sample.

An active bass filter to boost or attenuate low frequencies.

An active treble filter to boost or attenuate high frequencies.

Controls the stereo placement of each sound.

Mutes specified sound channels in the Mix Outputs.

Controls the volume of each sound in the total mix.

Allows creating new sounds by linking multiple channels.

Three velocity curves for pads/triggers and MIDI.

Feature to correct false triggering from other pads.

Procedure to format a new or existing FlashPac.

How to transfer individual sounds to a FlashPac.

Selects trigger source and adjusts triggering algorithms.

Configuration for using ddrum pads as trigger sources.

Using acoustic drum triggers with the system.

Sets the minimum signal level required to trigger a sound.

Explains how MIDI channels are used for communication.

Sets the MIDI channel for incoming signals.

Configures MIDI output mode (Global/Local).

How MIDI Out follows MIDI In settings.

Individual MIDI settings per channel, saved with kits.

Sets the MIDI channel for outgoing signals.

Disables internal sound triggering via pads.

Maps MIDI note numbers to ddrumAT channels.

Sets the duration of MIDI Note On/Off messages.

Controls sending program change messages.

Factory default values for MIDI parameters.

Handling of non-standard double note messages.

How the ddrumAT handles MIDI running status.

Advice on choosing a suitable sound system.

Recommendations for selecting headphones.

Notes on using the internal mixer and external mixers.

Importance of adjusting dynamics properly for sound perception.

Setting sounds to their natural pitch using parameter 64.

Adjusting decay for better kit mix and sound clarity.

Tips for using pitch bend, especially with toms.

Balancing sound levels for clear perception.

Using pitched sounds to create mallet instrument effects.

Mixing acoustic drums with ddrumAT sounds.

Quick method for setting up tom sounds across channels.

Demonstrates link function using a factory kit.

Creating new sounds by layering two sounds.

Using stereo linking for sound placement.

Layering short sounds for dynamic attack.

Using noise sounds as slaves for enhancement.

Layering snare sounds for resonance effects.

Example of crossfading snare sounds.

Examples of using expanded slave for dynamic effects.

Device for remote kit switching.

Accessory for percussion sounds like cowbells.

Cartridge for extra sound libraries.

RAM cartridge for kit backups and storage.

Programmable cartridges for sound samples.

Tubular rackstand system for drum setup.

Details on assembling and setting up the kick pad.

Notes on snare pad setup and its dual outputs.

Information on setting up tom pads.

Details on attaching tom triggers to hoops.

Information on fitting bass drum triggers.

Setup for the dual-mic snare trigger.

General cleaning and care instructions for the unit.

Precautions for pad temperature and care.

Cleaning and head replacement for tom pads.

Care and head replacement for the snare pad.

Cleaning and maintenance tips for the kick pad.