To Next PageTo Next Page
Need help?Do you have a question about the Claypaky SCENIUS UNICO and is the answer not in the manual?
General| Type | Moving Head |
|---|---|
| Light Source | LED |
| Wattage | 400 W |
| Focus | Motorized |
| Pan Range | 540° |
| Tilt Range | 270° |
| Effects | Animation Wheel, Prism |
| Control Protocols | DMX512, Art-Net, sACN, RDM |
| Connectors | PowerCON |
Select the DMX address for the control signal. Addresses between 001 and 512 can be selected.
Select the projector operating mode: Standard or Vector.
Set the Fixture ID to be assigned to the projector. An ID between 000 and 255 can be assigned.
Set Ethernet settings for the projector, including Control Protocol, Repeat on DMX, Universe, IP Address, and IP Mask.
Enable or disable the lamp remote control channel.
Configure Pan and Tilt reverse movement, channel inversion, and encoder operations.
Set the CMY color mixing system and configure fixed wheel shortcut for color change.
Select the 'Dimmer Curve' from Standard or Conventional options.
Configure 'Shutter on error' and 'Dimmer on Shutter' for automatic closing.
Select one of two dimming types: 1400W-1200W or 1200W lamp power.
Select the speed of the Rotating Gobo Change: Normal or Fast.
Select the speed of the Blades: Normal or Fast.
Activate or deactivate display brightness reduction in idle status.
Restore default values on all option menu items and relevant submenus.
Save or recall a previously stored configuration for User Preset 1.
Save or recall a previously stored configuration for User Preset 2.
Save or recall a previously stored configuration for User Preset 3.
Displays a list of errors that occurred when the projector was turned on. Can be reset.
View projector working hours (total and partial). Partial counter can be reset.
View lamp working hours (total and partial). Partial counter can be reset.
View how many times the lamp was turned on (total and partial). Partial counter can be reset.
View hardware and software versions for each electronic board in the projector.
View the percent errors for each electronic board installed in the projector.
View the level of projector DMX channels in bit (Val) and in percent.
View the speed of each fan installed in the projector.
Check the correct operations of each 'sensor' installed in the projector.
Check if the rotating gobo wheel 1 gobo indexing procedure should be run.
View the projector 'Network' parameters: IP address, IP mask, and Mac address.
Test the correct operations of effects using pre-saved Tests.
Access to advanced functions, recommended for trained technical personnel.
Explains the functions of the control panel buttons for menu navigation and selection.
Ensures optimal operation by cleaning parts subject to dust and grease deposits.
Detailed steps for cleaning the projector's filters.
Describes the initial steps for extracting effect modules from the projector.
Details the first stage of the physical extraction process for effect modules.
Details the second stage of the physical extraction process for effect modules.
Details the third stage of the physical extraction process for effect modules.
Procedure for removing the rechargeable battery from the projector.
Instructions for accessing and securing the lamp compartment.
Step-by-step guide for replacing the projector lamp, including warnings.
Instructions on how to centre the lamp using adjusting screws.
Procedure for replacing the bearing group within the projector.
Information on replacing rotating gobos and their specifications.
Details on coated glass gobos, their properties, and usage.
Illustrations showing the correct orientation for gobos.
