Claypaky SHARPY PLUS - Effects Module Removal

9
SHARPY PLUS
Continue
➔
4
.3 Effects module removal
2
L
ower side
1
Extraction of the effect modules - Fig. 13.
IMPORTANT: Grasp the modules using the support structure and not the details which could get damaged.
Insertion of the effect modules: Repeat the operations indicated in Fig. 13, 14 and 15 in reverse order.
NOTE:
- Do not disconnect wiring harnesses when the fixtures is switched-on, to avoid to damage electronic boards.
- Do not switch-on the fixtures with wiring harness disconnected.
13