Need help?Do you have a question about the Clean Water J-PRO-22 and is the answer not in the manual?
Details warranty exclusions for power surges, voltage spikes, freezing, direct sunlight, or rain exposure.
Guides on checking parts, turning off water heater power, choosing a location, and gathering parts.
Guidance on mounting the pump directly onto the solution tank for optimal priming.
Instructions on preparing tubing ends, connecting fittings, and using appropriate tubing types.
Steps for connecting the discharge tubing from the pump to the injection check valve in the pipe tee.
Instructions for connecting the suction tubing from the solution tank's foot valve to the pump's inlet.
Details on connecting the soft tubing from the pump's degassing port back to the solution tank.
Guide on wiring the flow meter cable to the J-PRO-22 pump cable correctly.
Procedure for priming the pump using water, adjusting the degassing valve, and initial start-up.
Guidance on setting the pump's strokes per gallon to achieve the desired pH range.
Recommendations for mixing citric acid solution and adjusting pump settings for target pH.
Troubleshooting steps for incorrect pH levels, focusing on pump strokes and solution dilution.
Procedure for preparing the pump and system for freezing temperatures by draining and flushing.
Information on ordering replacement parts like injection check valves, diaphragms, and foot valves.
General| Brand | Clean Water |
|---|---|
| Model | J-PRO-22 |
| Category | Water Pump |
| Language | English |
To Next Page