EasyManuals Logo

Cleanfix PowerDisc LS User Manual

Cleanfix PowerDisc LS
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
Technical Specification PowerDisc LS PowerDisc HS PowerDisc HD
Power supply 230 V 230 V 230 V
Brush motor power 1200 W 1200 W 1200 W
Brush speed 155
1
/min 410
1
/min 160
1
/min
Working width 44 cm 44 cm 44 cm
Operating height 37 cm 37 cm 37 cm
Cable length 12.5 m 12.5 m 12.5 m
Weight inclusive brush
with additional weights
30 kg 30 kg 43 kg
51 kg
Protection class I/IPX4 I/IPX0 I/IPX4
Noise level 55 dBA 55 dBA 55 dBA
Vibration strength handle <2.5 m/s
2
<2.5 m/s
2
<2.5 m/s
2
Torque 68 Nm 29 Nm 68 Nm
- OPERATING -
Commissioning / Operation
Please remember that the voltage in the building being cleaned must concur with that given on the machine’s
type plate.
Assembly instructions
The motor head and bar are supplied separately packed.
First release the hexagon socket screw in the shaft adjustment unit (9).
Then feed the bar (6) gently as far as it will go into the shaft adjustment unit (9).
Align the handle bar (1) parallel with the wheels (10), so that the open side of the housing of the top shaft
element (3) is facing to the rear.
Then tighten the hexagon socket screws (9) again.
Wind the electric cable (12) around the handle bar (1) and cable hook (8).
Preparations for use
Grasp the handle bar (1) with both hands and tip the machine until it is resting on
both wheels (A).
Then wheel the machine to its place of work and plug the electric cable into the
power supply. Lay the accessories (20), i.e. brush or drive plate with pad, on the
oor.
Now tip the machine back onto the wheels and push it over the brush (or drive plate)
until the drive star and brush flange are vertically aligned. Lower the machine onto
the brush.
Place the single disc machine on the working element (B).
Then squeeze the shaft adjustment lever (4) and lower the bar (6) into its working
position. Both arms should be extended loosely downwards. Align the machine hori-
zontally above the working element (brush or drive plate), press the switch lock (3)
and press the brush motor switch (2) briefly.
The accessory automatically engages.
| 15
Technical Specification
20
1
A
B
®
®
4
3
2
2
6
®
6
®
20
1
A
B
®
®
4
3
2
2
6
®
6
®
English

Table of Contents

Other manuals for Cleanfix PowerDisc LS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cleanfix PowerDisc LS and is the answer not in the manual?

Cleanfix PowerDisc LS Specifications

General IconGeneral
BrandCleanfix
ModelPowerDisc LS
CategoryFloor Machine
LanguageEnglish

Related product manuals