EasyManuals Logo

Cleanfix PowerDisc Series Manual

Cleanfix PowerDisc  Series
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
English 10
5. Routine cleaning with PowerDisc HS
For routine cleaning, your machine is equipped with the
following accessories:
- Driving disc for Pads and corresponding pad.
Fill the spray can with the desired product.
Fit the drive plate with the desired pad.
Start the machine.
When you pull the Spraymaster lever a few times the
cleaning agent is sprayed onto the floor. Now start
cleaning immediately until a shine is produced.
We advise cleaning the surface in relatively small
areas at a time.
The machine is ideal for cleaning with polymer dispersions.
The coating’s resistance to foot traffic and general wear
and tear is preserved. Streaks and marks are easier to
remove.
6. Polishing
For polishing, equip your machine with the following
accessories:
- Driving disc for Pads and corresponding pad.
Fit the drive plate with the pad.
Then start the machine.
7. Service
For repairs, please contact your specialist wholesaler
or one of the service shops.
You will be expertly and quickly served.
This machine is only intended for use on level surfaces
with a maximum gradient of up to 2 %.
This machine is not approved for use on public paths
and roads.
8. Servicing instructions
The following instructions should be
observed:
When cleaning and servicing the machine, replacing
parts or when changing over to a different function,
switch off the drive and remove the plug.
The power supply lead must not be damaged by
driving over it, crushing, tugging etc.
Check the power supply lead regularly for signs of
damage.
The machine must not be used if the power supply
lead is not in perfect condition.
When using or replacing the power supply or
equipment supply leads, use only those specified by
the manufacturer.
When replacing the plug-and-socket connectors of
power supply or equipment supply leads, splash
protection and mechanical strength must be assured.
When transporting the machine in lifts, put the
shaft/bar in a vertical position so that it cannot catch
on the lift walls.
The shaft/bar is automatically secured against recoil
by the patented shaft/bar adjustment unit.
Only the spray and cleaning agents suitable for the
machine’s purpose may be used.
Never use highly flammable, combustible, toxic,
health-hazardous, corrosive or irritant substances.
Repairs, including the fitting of spray agent lines and
hoses, may only be carried out by approved customer
service shops or by specialists in this field who are
familiar with all the relevant safety regulations.
9. Storage
When the machine is not being used, store it in a dry place
and in normal room conditions (not below under 0°C).
10. Environmental protection
The packaging material can be recycled.
Please do not throw the packaging
material into household waste; please
send it for recycling.
Old appliances contain valuable materi-
als that can be recy-cled; these should
be sent for recycling.. Batteries, oil, and
similar substances must not enter the
environment. Please dispose of your old
appliances using appropriate collection
systems.

Other manuals for Cleanfix PowerDisc Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cleanfix PowerDisc Series and is the answer not in the manual?

Cleanfix PowerDisc Series Specifications

General IconGeneral
BrandCleanfix
ModelPowerDisc Series
CategoryFloor Machine
LanguageEnglish

Related product manuals