Why CleanFreak DURA-18HD Floor Machine has no power?
If your CleanFreak Floor Machine has no power, it could be due to several reasons: * The wiring may not be connected correctly or there may be bad wiring. Check the wiring or contact a CleanFreak Distributor. * There may be a bad brush motor. Contact a CleanFreak Distributor. * The carbon brushes may be worn out. Contact a CleanFreak Distributor.
What to do if vacuum motor does not run on CleanFreak DURA-18HD?
If the vacuum motor on your CleanFreak Floor Machine isn't running, it could be due to: * Incorrectly connected or faulty wiring. Check the wiring or contact a CleanFreak Distributor. * A bad vacuum motor. Contact a CleanFreak Distributor. * Worn-out carbon brushes. Contact a CleanFreak Distributor.
How to fix little or no solution flow in CleanFreak Floor Machine?
If your CleanFreak Floor Machine has little or no solution flow, it could be due to: * A bad ball valve. Contact a CleanFreak Distributor. * A bad solution valve. Contact a CleanFreak Distributor. * The ball valve position needing adjustment. When the ball valve is in a horizontal position, the amount of solution flow is maximum.
What to do if CleanFreak DURA-18HD Floor Machine has poor water pick up?
There are several reasons for poor water pick up in your CleanFreak Floor Machine: * The squeegee may be clogged. Clean any debris off the squeegee with a damp towel. * The squeegee blades may be worn. If so, install new squeegee blades. * The squeegee may not be mounted correctly. Confirm that the squeegee assembly is securely fastened to the machine and not loose fitting. * Vacuum hoses may have a hole or are loose. Check hose connections and make sure they are firm, replacing the hose if damaged. * The vacuum hose may be clogged. Check the hose for debris and remove any clog. * The drain hose stopper may be loose. Tighten the drain plug. * The vacuum motor may be loose. Tighten the vac motor mounting screws, being careful not to overtighten or cause damage. * The cover ...
Covers safe practices for operating the machine, including pre-operation and during use.
Alerts regarding the risks of flammable materials causing explosions or fires.
Identifies and labels the main structural parts of the floor scrubber.
Instructions for unpacking the machine and checking contents.
Steps to prepare the machine before its first use.
Procedure for attaching the pad driver or brush to the machine.
Steps for mounting the squeegee assembly onto the machine.
Guidance on how to fill the machine's solution tank with water and detergent.
Step-by-step guide for operating the floor scrubber.
Important checks to perform while the machine is in use, such as foam level.
Steps for draining the machine's tanks after use.
Routine tasks to perform daily to maintain the machine.
Tasks to be completed on a monthly basis for machine upkeep.
Specific maintenance requirements for the machine's motors.
Guidelines for properly storing the machine when not in use.
General| Model | DURA-18HD |
|---|---|
| Category | Floor Machine |
| Motor | 1.5 HP |
| Pad Size | 18 inches |
| Power Cord Length | 50 feet |
| Speed | 175 RPM |
To Next Page