The CleanLight Pro
EN
Congratulations on your purchase of the CleanLight Pro!
Please read through these user instructions carefully before using this device!
UV light has been used for things like disinfecting drinking water and disinfecting the air in hospitals for decades. Nowadays farmers and
gardeners use this UV technology, better known as the CleanLight method, as a replacement to pesticides.
The CleanLight Pro means you can now also use the CleanLight method at home.
The CleanLight Pro gives you the opportunity to protect your much loved plants, flowers and crops against bacteria, moulds and viruses in a
biological and environmentally friendly manner. Chemical pesticides damage the environment and certainly don’t benefit the taste of edible
crops.
Plus it’s very bad for your health. The CleanLight Pro doesn’t give your plants, flowers or crops a dose of pesticides, but a dose of UV light.
UV has a very effective and deadly effect on viruses, moulds and bacteria.
What can you use your CleanLight Pro for?
- Plants,
- Flowers,
- Vegetables,
- Fruit and
- Herbs
CleanLight Pro Contents:
- CleanLight Luminaire
- CleanLight Lamp (36 watt)
- UV Safety Glasses
- Gloves
U
serstip:
replace your lightbulb (36 watt) at least every three years.
Safety
This device produces harmful radiation. Direct contact can be dangerous for both eyes and skin. Therefore make sure you only check the UV
lamp’s functioning with the UV protective safety glasses and make sure your skin isn’t exposed to the UV light.
- Always remove the plug from the socket before carrying out any maintenance or repair activities on the device.
- For safety purposes, only connect the device to a group with an earth leakage circuit breaker with a switch o current of less than 30 mA.
- Don’t allow children to use this product in order to prevent risk of injury. The device should only be used by adults and must be kept away
from children.
- This device is not suitable for use by people (including children) with a physical, motor or mental limitation or a lack of experience or
knowledge of this product, unless the use is being controlled by a capable supervisor.
- The device shouldn’t be immersed in water or become wet.
- Always remove the plug from the socket when the device is not in use.
- Never insert/remove the plug into/from the socket when standing in a puddle of water or with wet hands.
- Make sure the plug remains dry at all times.
- The cable which goes with this device is not replaceable. The device’s entire electrical section needs to be replaced in case of damage to the
power cable. Never remove the plug, but ensure the electrical section stays intact. An electrical section with a cut o plug will not be covered
by the guarantee.
- Never carry the device by its cord.
- The lamp will remain hot for around 10 minutes after you switch the device o.
To Next Page
Loading...
Need help?
General
