EN 18
■ Remove the mains adapter from the plug socket if a fault occurs during charging or if
a thunderstorm is expected.
■ When you pull it out of the plug socket, always pull on the mains adapter and never
the mains cable! Never pull or carry the device by the mains cable.
■ Make sure that the mains cable is not squashed, bent or laid over sharp edges and
does not come into contact with hot surfaces. Do not wrap the mains cable around
the device.
■ The device should only be used if it has been fully and correctly assembled! The
dust container, the fi lter holder and the fi lters must be inserted and must not be
damaged! If the dirt were to get inside the motor unit, this could damage the motor.
■ Protect the device from heat, naked fl ames, extreme temperatures, persistent mois-
ture, wet conditions and collisions.
■ Use only original accessories from the manufacturer in order to guarantee that there
is no interference that may prevent the device from working and to avoid possible
damage.
■ Do not place or lay any heavy objects on the device or accessories.
NOTICE – Risk of Damage to Material and Property from Batteries
■ Before inserting the battery, check whether the contacts are clean and clean them if
necessary.
■ Remove a dead battery from the device immediately. Clean the contacts before a
new battery is inserted.
■ The battery must not be taken apart, thrown into a fi re, immersed in liquids or
short-circuited.
09196_09197_Inlay_DE-EN-FR-NL_A5_V2.indb 1809196_09197_Inlay_DE-EN-FR-NL_A5_V2.indb 18 22.05.2019 12:09:5822.05.2019 12:09:58
To Next Page
Loading...
Need help?
General
