28
STEEL STORAGE
3 | MEASURE AND ADJUST BEAM WIDTH
Measure from end leg to end leg until you find the approximate width of the
work surface. Insert the screw through the overlapping beam slots and into
the locking screw and lever. Slightly tighten the screw. DO NOT fully
tighten. Insert beam grommet covers.
4 | SECURE THE MAIN SURFACE
Position the surface on the desk frame. Align the outer sides of the surface flush
and parallel with the outer sides of the end legs, adjust if not flushed. Insert
wood screws into the leg brackets and secure to the underside of the surface.
Align Flush
Align Flush
To Next Page
Loading...