Clearaudio Nano phono

To Next Page

Technische Daten

- Technical data:

Verstärkung bei 1 kHz: max. 69 dB (MC-Betrieb/

Mode

)

Amplification:

max.

49 dB (MM-Betrieb/

Mode

)

Verstärkung / Gain control von / from 34 to 67 dB

Eingangsimpedanz:

Input load:

47 kΩ / 220pF / MM / MC

MM / MC – Eingang: schaltbar mit Steckbrücke (auf Unterseite)

MM / MC - input: switchable (at bottom)

Schneidekennlinien-Entzerrung: Nach RIAA (Zeitkonst.:

RIAA:

75µs / 318µs / 3180µs)

RIAA Genauigkeit: ± 0,4 dB

RIAA accuracy:

Klirrfaktor: 0,04% (IEC A)

THD:

Signal/Rauschabstand: 67 dB (A) (MC-Betrieb/

Mode

)

S/N:

84 dB (A) (MM-Betrieb/

Mode

)

Übersprechdämpfung: > 80 dB bei 1 kHz,

Channel separation:

gegenüberliegender Kanal

kurzgeschlossen

Maximale Ausgangsspannung: 10 V eff. (1 kHz)

Max. output voltage:

Spannungsversorgung: 16 V AC (< 500 mA)

Power supply:

(externes Steckernetzteil,

Kunststoffgehäuse)

(external power supply)

Ausgänge: asymmetrisch (CINCH)

Outputs:

asymmetrical (RCA)

Gewicht: ca. 600 g (Vorverstärker und Netzteil)

Weight: (Preamp and power supply)

Abmessungen ( b x t x h ): 80 mm x 106 mm x 25 mm

Dimensions ( w x l x h ):

(Technische Änderungen vorbehalten -

Technical changes are subject without notification)

Stand: 10/2010

clearaudio

electronic GmbH 2010

Bedienungsanleitung

User Manual

Nano phono

Nano phono „H“ headphone

Nano Phono

Nano Phono Headphone

Need help?

Do you have a question about the Clearaudio Nano phono and is the answer not in the manual?

Summary

Nano Phono Setup and Operation

Inbetriebnahme (Setup)

Instructions for initial setup, including jumper settings for MM/MC modes and subsonic filter.

Important Notice

Ensuring adequate airflow for cooling by not covering the device during operation.

Tip for Power Supply

Guidance on finding the optimal polarity of the external power supply for best sound.

English Setup Guide

Steps for setting operating mode (MM/MC) and subsonic filter via jumpers.

Attention to Device Placement

Warning against covering the device, which can lead to overheating.

Power Supply Polarity Notice

Advice on determining the correct power supply polarity for optimal performance.

Summary

Nano Phono Setup and Operation

Inbetriebnahme (Setup)

Instructions for initial setup, including jumper settings for MM/MC modes and subsonic filter.

Important Notice

Ensuring adequate airflow for cooling by not covering the device during operation.

Tip for Power Supply

Guidance on finding the optimal polarity of the external power supply for best sound.

English Setup Guide

Steps for setting operating mode (MM/MC) and subsonic filter via jumpers.

Attention to Device Placement

Warning against covering the device, which can lead to overheating.

Power Supply Polarity Notice

Advice on determining the correct power supply polarity for optimal performance.