To Next PageTo Next Page
Need help?Do you have a question about the CLEARblast 150 and is the answer not in the manual?
Adherence to site manager, safety clothing, safe work environment, barriers, and signs.
Read manual, ensure water, wear eye, ear, dust, and respiratory protection.
Adjustments for Blast Pressure, Media Dosage, and function/mode selection.
External hose connections, air supply gauge, and water tank drain.
Blast hose, nozzle, air supply, air hose, water hose, and media are required.
Extension blast hose and rust inhibitor for specific applications.
Steps for pressurizing, adding media, and preparing for blasting.
Options for Water and Media, Water Only, or Air Only blasting.
Releasing the emergency stop and adjusting blast pressure/dose.
Steps to safely stop, depressurize, drain, and restart initial setup for reloading.
Running water/air only modes, stopping, and draining the slurry dump valve.
Information on media capacity, suggested settings, and trigger functionality.
Contact info for support and recommended blast pressure/abrasive dose settings.
Tips on loading media, preventing clogs, blasting at elevation, and hose handling.
Disconnect water inlet hose and drain tank/vessel via drain and slurry valves.
Connect to air supply for winterizing using a small shop compressor.
Disconnect pump line and place into windshield washer fluid/deicer.
Run system in "Pressurize" mode with deicer in the pump line for 8-10 seconds.
Run system in "Blast" mode with deicer in the pump line for 5 seconds.
Run in "Depressurize" mode to drain water and piping.
Flush with wash hose until deicer emerges; leave drain valves open.
Leave 10-20% of hose length on the ground for heights over 10 feet.
Lists components for Image 1 (Pump, Valves) and Image 2 (Controls, Regulators).
Detailed listing and labeling of components shown in Image 1.
Detailed listing and labeling of components shown in Image 2.
Detailed listing and labeling of components shown in Image 3.
Detailed listing and labeling of components shown in Image 4.
Details on extension hoses, nozzle extensions, and various nozzle sizes for different jobs.
Flash rust inhibitor (Holdtight 102) and alternative media types for specialized blasting.
One-year bumper-to-bumper warranty excluding expendables; details misuse and modification exclusions.
Lists contents of the spare parts kit, including tubing, gauges, and valves.
Detailed schematic and repair kit for the WIWA water pump air end.
Detailed schematic and repair kits for the WIWA water pump water end.
Schematic and seal/diaphragm kits for the spring-closed diaphragm valve.
Schematic and repair/seal kits for the main air regulator.
Schematics and repair kits for general purpose and coalescing micro filters.
General| Brand | CLEARblast |
|---|---|
| Model | 150 |
| Category | Cleaning Equipment |
| Language | English |
