9
send an HDMI signal from your transmitter (TX) to
multiple TV’s/monitors/projectors. You can add up
to 3 additional receivers (4 receivers total) to one
Extend+Expand™ system. To pair an additional
receiver (RX) to the transmitter (TX), follow the
steps below:
a. Connect both the transmitter (TX) and add-on
receiver (RX) to their power adapters.
b. Use an HDMI cable to connect the transmitter’s
(TX’s) HDMI IN port to the receiver’s (RX’s) HDMI
OUT port.
c. When the green LED lights on the transmitter
(TX) and receiver (RX) stay solid green, the
pairing is complete, and you may disconnect the
HDMI cable.
To Next Page
Loading...