11
How To Put Your Receiver (RX) On Your Existing
WiFi Network (OR Change Language)
You can add your receiver (RX) on your existing
WiFi network so that your smart devices (i.e. iPhone)
do not need to connect to the receiver (RX) WiFi
network. Instead, these devices can just stay
connected to your local network.
1. Unplug & disconnect any transmitters (TX).
2. Plug in the receiver (RX) to your TV, monitor, or
projector via HDMI.
3. Connect the USB-C port of the receiver (RX) to
a USB port or power supply for power
(required).
4. Connect your computer, phone, or tablet to the
RX’s WiFi network shown on the top of your TV
screen. (For example, SSID: RXxxxxx,
Password: 12345678).
To Next Page
Loading...