13
How To Pair A New Extra Transmitter (TX)
You can purchase additional transmitters (TX) from
ClearClick® and pair them with the receiver (RX).
Simply follow the same procedure as usual to connect the
transmitter (TX) to the receiver (RX). Make sure the
transmitter (TX) is connected to your video source (such
as a laptop). You may also need to provide power to the
transmitter via the USB-C port.
After this, the transmitter (TX) will automatically pair to the
receiver (RX), but it may take a moment for the transmitter
(TX) to turn blue. Then, you can press the button to start
transmitting to the receiver (RX).
How To Un-Pair A Transmitter (TX) From a
Receiver (RX)
(Note: This step is not necessary for most users.)
To un-pair a transmitter (TX) from a receiver (RX), use a
pin or paperclip to hold down the button inside the hole at
the end of the transmitter (TX) for two seconds. This will
un-pair/un-link the transmitter (TX) and receiver (RX).
To Next Page
Loading...