ESSENTIAL -1, -2, -3
10 11
UK 0238 202 6522 infraredsauna.co.uk
EU +49 (0) 4040 110 162 clearlightsaunas.eu
Assembly Instructions Cont’d
6 - CONNECT HEATER CONNECTION UNDER BENCH
7 - INSTALLING BENCH
Follow the connections as in the photo below.
1. Connect the under bench support heater connection to the connector coming out of the wall.
2. Connect the cable coming out of the oor to the other connector coming out of the wall.
3. Connect the green ELF grounding wires together.
4. Keep in mind, there is no incorrect way to connect these connectors as long as you connect the male
two wire connectors to the female two wire connectors and the male single green wire connectors to the
female green single wire connectors.
Install the bench panel by sliding it over the horizontal bench guides on the side panels. Be careful not to
scratch the adjacent panels when sliding in the bench.
Push the bench all the way in until it touches the back panel and is securely in place.
Be sure that the bench is pushed all the way back until it slides under the heater guard to secure the bench in
place.
L
E
F
T
TO
P
BOTTO
M
FR
O
N
T
B
L
AC
K
L
E
F
T
TO
P
BOTTO
M
F
R
O
N
T
B
L
AC
K
To Next Page
Loading...
