11
Assembly Instructions Cont’d
Install the bench panel by sliding it over the horizontal bench guides on the side panels. Be careful not to
scratch the adjacent panels when sliding in the bench.
Push the bench all the way in until it touches the back panel and is securely in place.
The bench is reversible. One side is ergonomic and one side is at. You can reverse the bench after the
sauna installation is nished. Be sure that the bench is pushed all the way back until it slides under the
heater guard to secure the bench in place.
Optional: After the bench is installed, you
can slide in the included wood pieces
to prevent the bench from sliding left to
right. One piece can be placed on each
side next to the bench. If you decide to ip
the reversible bench over, please remove
the wood pieces rst.
7 - INSTALLING THE BENCH
LL
EE
FF
TT
TT
OO
PP
BBOO
TT
TTOO
MM
FFRR
OO
NN
TT
BB
LLAA
CC
KK
L
E
F
T
T
O
P
B
O
TTO
M
F
R
O
N
T
B
L
AC
K
1. Set the wood portion of
the roof on the back roof
guide. Besure to slide the
roof back against the back
wall.
8 - INSTALLING WOOD PORTION OF ROOF
To Next Page
Loading...
