82
Using Your Sauna Control Panel
USING YOUR INFRARED SAUNA
Fahrenheit & Celsius
You can alternate between Fahrenheit and Celsius by pressing the F/C button on the keypad.
Inside / Outside Light
1. Press the button labeled “INSIDE” to turn on or o the Interior light.
2. Press the button labeled “OUTSIDE” to turn on or o the exterior light and the heater backlights.
Full Spectrum
Press the “Full Spectrum” button to change the intensity of the front Full Spectrum heaters.
The heaters will turn on initially at 100%.
1. Press the button once to change to 50% intensity.
2. Press the button a second time to change to 75% intensity.
3. Press the button a third time to change to 100% intensity.
Reservation
You can preset your sauna to turn on up to 36 hours in the future:
1. Press the POWER button to turn on your sauna.
2. Set the desired temperature and time that you would like the sauna to start at when the power comes
on.
3. Press the RESERVE button.
4. The time will begin to ash.
5. Press the TIME UP button to set the number of minutes or hours ahead you would like your sauna to
turn on.
6.
The range is 1 - 36.
7. Set the maximum set temperature by pressing the TEMP UP or TEMP DOWN button.
8. The keypad will ash and the time will count down in one hour increments until the sauna turns on.
9. To cancel the reservation, press the “POWER” button once to turn o the sauna.
AUX
The AUX button will be used to control additional features that can be added to your sauna. The instructions
to use these features will be included when the item is purchased.
USING YOUR INFRARED SAUNA
Note: The intensity will be
displayed on the keypad.
To Next Page
Loading...
