Clearlight SANCTUARY 2 - Page 80

81
Using Your Sauna Control Panel
USING YOUR INFRARED SAUNA
Unlike a traditional sauna, infrared heats the body directly. Air temperature
in the sauna is not as important as the type and quality of the infrared
being received. We recommend the following protocol:
a. Turn the sauna on for 10 minutes to allow the heaters to come up
to optimal temperature and for the cabin to warm to a comfortable
temperature.
b. When you enter the sauna, set the time to the desired session
time and turn the thermostat up to 150+F / 65C. This will keep
the heaters are on the entire time to ensure that you are receiving
constant
infrared heat. During a 30 minute sauna session, the air
temperature will reach between 115-125F / 46-51C depending on
the starting ambient air temperature.
c. Sit back and relax. Enjoy your sauna session.
When connected to the properly grounded power source, your Clearlight
®
sauna will turn ON to the set
temperature and count-down with a few pushes of the Power button.
System On/O
1) Press the “POWER” button once to
turn on the sauna.
2)
Your session will automatically
end after the programmed timer
expires.
3)
ress the “POWER” button at any
time turn o the sauna.
Sauna Session Time
You can set the duration of your sauna
session for a maximum of 60 minutes.
Press the TIME UP or TIME DOWN buttons
to increase or decrease your desired sauna
session time in 5 minute increments.
When you have reached your desired
time, release the button.
Controlling the Set Temperature
You can program your sauna for a maximum temperature of 175°F (80°C). Press the TEMP
UP/DOWN (+/-) buttons to set the desired temperature. When the display shows your
desired temperature, release the buttons. Press either the TEMP UP or TEMP DOWN
buttons during your sauna session to manually control the desired cabin temperature.
*See “Instructions For Use” on next page for recommendations.