70
Assembly Instructions Cont’d
1. Place the left side wall in the slot in the
oor. Lift the side wall up about 4” (10cm)
higher than the backwall panel (See Picture
1).
2. Place the side wall panel against the back
wall (See Picture 2), then slide down side
wall panel until the two panels are equal
height. (See Picture 3).
3. Repeat the steps above for the right side
wall panel.
6 - INSTALL THE LEFT AND RIGHT SIDE WALLS
Left Side Wall Connected Right Side Wall Connected
Picture 1 Picture 2 Picture 3
If the panels still seem too tight to
come down all the way, try backing o
the bracket screws by one half turn
with a Phillips head screwdriver on the
female brackets.
To Next Page
Loading...
