Clearlight SANCTUARY - Page 37

38
SANCTUARY 3
Assembly Instructions Cont’d
6 - CONNECT HEATER CONNECTION UNDER BENCH
Plug in the connectors under the bench as follows:
Left Side Wall:
1.
Locate the short cable coming out of the oor with a single black and white cable and a single green
cable. This cable is comes threaded through the hole of the white cable cover.
2.
Locate the cable coming out of the under bench support. Feed this cable through the open hole in the
bottom of the white cable cover.
3. Connect these cable to the cables coming out of the white box on the left side wall. You can connect
the black and white cables from the oor and underbench support to any black and white cable coming
out of the box as long as you match cable colors. You can connect the green cables to any of the green
cables coming out of the box as long as you match cable colors.
4.
Screw on the cover to cover the wires on the side wall.
You can plug any male connector to any female one as long as
the colors match.
Back Wall:
1. Locate the longer cable coming out of the oor that feeds
through a hole in the white cover.
Connect the longer cable coming out of the oor to the like
connector in the cables coming out of the white box on the
back wall. Connect the cable with two wires to the cable
with two wires in the back all. Connect the cable with four
wires to the cable with four wires coming out of the back
wall.
2.
Screw on the cover to cover the wires on the back wall.
3. The additional plate on the back wall is used to connect
the Vibration Resonance Therapy (VRT) to your sauna. If
you purchased the VRT, follow the installation instructions
included with the VRT.