ClearPix IDM12DN-H2 - Setting the IP Address Through the ARP;Ping Method

24 pages

To Next Page

To Previous Page

Setting the IP Address

Through the ARP/Ping Method

Complete the following steps to configure the camera to use a specific

IP address:

1. Locate and copy down the MAC Address (MAC) listed on

the Serial Number Tag for reference.

2. Open a Command Prompt window and enter the following

commands:

a. arp -s <New Camera IP Address> <Camera

MAC Address>

For example: arp -s 192.168.1.10 00-18-

85-12-45-78

b. ping -l 123 -t <New Camera IP Address>

For example: ping -l 123 -t 192.168.1.10

3. Reboot the camera.

4. Close the Command Prompt window when you see the

following message:

Reply from <New Camera IP Address>: ...