ClearWater Lights CANopener - User Manual

Allows independent dimming of two sets of lights with 11 brightness levels, controlled via the Wonder Wheel.

Dimmer automatically compensates using the bike's photocell for day, night, and high beam illumination.

Manually deactivate lights using the turn signal cancel button without a separate switch.

Clearwater lights can dim automatically when turn signals are activated.

Programmable to illuminate or strobe when the horn button is pressed (off-road use).

Lights programmable to activate or strobe with high beam or flash-to-pass button (off-road use).

Lights programmable to strobe when the hazard button is toggled on/off (off-road use).

Optional module with standard brake/tail, California-legal strobe, and speed-sensitive modes.

Provides auxiliary turn, horn, and high beam relay drives. Use relay for accessories.

Resets all CANopener functions to their default settings.

Shows the CANopener module location under the seat for R1200GSW/GSAW models.

Illustrates the CANopener module placement for the K1600GT motorcycle.

Details the CANopener module mounting spot for the R1200RTW motorcycle.

Shows the CANopener module installation location for R1200R/RS models.

Illustrates the CANopener module mounting location for the S1000XR motorcycle.

Step-by-step guide to enter dimming mode and adjust brightness for Darla/Glenda and Krista/Erica/Sevina lights.

Settings adjust automatically based on ambient light; manual adjustment via cover.

High beam activates 100% brightness; dimming requires specific commands in high beam.

Pre-set brightness levels for Darla/Glenda and Erica/Krista/Sevina lights for low beam (day/night) and high beam.

Manually deactivate lights by holding TSC for 2 seconds; automatic shut-off with 3 TSC presses.

Option to dim all Clearwater lights to the lowest setting when turn signals are activated.

Three modes: horn does not affect lights, horn activates lights 100%, or horn strobes lights.

Three modes for lights in conjunction with high beams or flash-to-pass.

Lights flash for 2 seconds when flash-to-pass is triggered 3 times (Version 1.91+).

Two modes: OFF (no flash) or strobe when hazard button is held or toggled.

Provides 12V signals for auxiliary turn, horn, and high beam relay drives.

Identifies wire colors for Ground, Brake/Tail Light, 12V Motory Start, High Beam, and Horn.

Procedure to reset CANopener to factory settings using TSC, turn signal, and flash-to-pass buttons.

Outer ring LEDs (A) controlled by holding TSC for 2 seconds, similar to Kristas/Ericas/Sevinas.

Inner LEDs (B) come on with the engine, can be shut off by holding TSC Left for 5 seconds.

Inner and Outer ring LEDs are dimmed independently using specific channels.