ClearWater CD-2000 - Page 32

32

Ozone Generator Care
Awordofcaution:Thereisextremelyhighvoltageinsidetheozonegenerator.Ifyoususpectaproblem,disconnectthepowerto
theunitattheservicedisconnectboxormainelectricalpanelandimmediatelycontactyourClearWaterTechdistributor.Inspect
theozonedeliverylinecheckvalvesdailyforwaterseepageandreplacetheinjectorcheckvalveyearly.
•Cleantheozonegeneratorcabinetairlters:
Theseltersmustbecleanedregularly.Dependingonthelocationoftheunit,itmaybenecessarytocleantheairlters
monthly.Onthebottomofthecabinetarelterelements(seeillustrationbelow).Theseareairintakeelementsforthe
cooling fans and may therefore require the most frequent cleaning. All elements may be cleaned with soap and water
and should be dried completely before reinstalling. Note: In a clean environment, these procedures may only need to
be performed every three months. IMPORTANT: CLEAN THESE FILTERS REGULARLY! FAILURE TO DO
SO WILL PROMOTE OVERHEATING AND WILL VOID THE WARRANTY!
•Checkvalves:
Thesystemisequippedwithtwocheckvalves:oneattheozonegeneratorozoneoutletandoneontheventuri
injector.Thepurposeofthesecheckvalvesistopreventwaterfrombackingupintotheozonegenerator.TheTeon
®
ozonedeliveryline(s)shouldbeinspecteddailytoinsurewaterisnotowingbackintotheozonegenerator.Check
valvesshouldbereplacedyearly.Note:Theonlytimeitispossibleforwatertoowbacktowardtheozonegeneratoris
during a system shutdown. Always inspect for water seepage during this time.
•Dielectrictubes:
Dielectrictubesarelocatedinthereactionchambersoftheozonegenerator.Thesetubesshouldbeinspectedperiodical-
lyandcleanedifnecessary.Onceeachyear,removeonereactionchamberandinspectthedielectrictubefordebris.If
the tube is clean and free of any debris, oil or dirt, it may be replaced and no further maintenance is required. If the tube
isdirtyorcracked,alldielectrictubesmustbeinspectedandcleaned.Crackeddielectricsshouldbereplaced.Please
consultyourClearWaterTechdistributor,astheimproperinstallationofthedielectricmaycausesafetyproblems!
Since the air that is introduced into the reaction chambers is high quality, the dielectric tubes should remain clean for at
least one year before inspection is required.
Fan
Cabinet Bottom Plate
Fingerguard
Fan Filter Element
Fan Filter Grill
(snaps on and off)