ClearWater CD-2000 - Page 7

7
When installing and using this
electrical equipment, basic safety precautions should always be followed, including the following:
1.
READ AND FOLLOW ALL INSTRUCTIONS.
2. SAVE THESE INSTRUCTIONS.
3.
 Allelectricalconnectionsshouldbemadebyalicensed,qualiedelectrician.
4. Before attempting any electrical connections, be sure all power is off at the main circuit breaker.
5. Installallelectricalequipmentatleastvefeetfromanyopenbodyofwaterusingnon-metallicplumbing.
6. Installcheckvalvesandavacuumbreaktopreventwaterfromcontactingtheelectricalequipment.
7. Theelectricalsupplyforthisproductmustincludeasuitably-ratedswitchorcircuitbreakertoopenall
 ungroundedsupplyconductorstocomplywithSection422-20oftheNationalElectricalCode,ANSI/NFPA
 70-1987.Thedisconnectingmeansmustbereadilyaccessibletotheoperator(s)butinstalledatleastve
feet from any open body of water.
8. Besuretobond(ground)thesystemusingthecopperbondinglugonthebottomoftheozonegenerator.The
system should be bonded with solid copper wire conforming with all local, state and national electrical codes.
9. Thesystemshouldbesizedappropriatelyforitsintendedusebyaqualiedprofessionalfamiliarwiththe
 application.Thisequipmentmustbevalidatedbythemanufacturerforitsintendeduse.
Safety Information
(continued)