CleaverBrooks CB-LE Series - Page 39

Chapter 2 — Burner Operation and Control
Part No. 750-184 2-19
Figure 2-17 Heavy Oil Flow
OIL HEATER
(ELECTRIC)
OIL HEATER
THERMOSTAT
(STEAM)
OIL HEATER
SHELL
FUEL OIL
STRAINER
OIL SUPPLY
PRESSURE
GAUGE
OIL HEATER
THERMOSTAT
(ELECTRIC)
OIL RELIEF
VALVE
STEAM HEATER
PRESSURE GAUGE
STEAM HEATER
SOLENOID VALVE
STEAM PRESSURE
REGULATOR
CHECK VALVE
STEAM STRAINER
STEAM SHUTOFF
VALVE
CHECK
VALVE
STEAM TRAP
FUEL OIL
SUPPLY PUMP
FUEL OIL
STRAINER
NOT SUPPLIED
BY CLEAVER BROOKS
PRIMING TEE
CHECK VALVE
VACUUM GAUGE
SHUTOFF
VALVE
NOTE: CONDENSATE FROM STEAM
TRAP MUST BE WASTED AND PIPED
TO A SAFE POINT OF DISCHARGE.
CORRESPONDING HOT WATER HEATING COMPONENTS.
STEAM GENERATORS. REFER TO FIGURE 1-2 FOR
NOTE: DIAGRAM SHOWS COMPONENTS USED WITH
BY-PASS
MANUAL
VALVE
FUEL OIL
THERMOMETER
REGULATOR
OIL PRESSURE
OIL MODULATING
CAM
PRESSURE
RELIEF VALVE
OIL RETURN
PRESSURE
GAUGE
ORIFICED
VALVE
OIL BURNER
PRESSURE
GAUGE
VALVE
OIL METERING
SWITCH
TEMPERATURE
LOW OIL
CONTROLLER
FUEL OIL
VALVE
OIL SOLENOID
VALVE
AIR PURGE
CHECK VALVE
AIR PURGE
CHECK VALVE
AIR PURGE
RECEIVER TANK
AIR OIL
LUBE OIL
PROVING SWITCH
ATOMIZING AIR
LUBE OIL
STRAINER
SWING CHECK VALVE
AIR STRAINER
ATOMIZING AIR
MANIFOLD
BLOCK
PRESSURE GAUGE
NOZZLE AIR
OIL BURNER NOZZLE
* THESE ITEMS ARE USED ON HIGH
PRESSURE GENERATORS ONLY
INLET
OIL
FUEL
AIR PUMP
RETURN
FUEL OIL
STEAM INLET
ATOMIZING AIR PRESSURE
FEEDBACK CONTROL TUBING