2
3
EN
EN
Use
Pairing
Connect the remote socket into a wall socket. The LED-
indicator on the side of the remote socket starts flashing
and it automatically enters pairing mode for the next
30 seconds.
Pair with a remote control (sold separately):
Select the channel you want to use on the remote control and press the ON
button in that row within 30 seconds. The indicator on the remote socket turns
solid red and emits a clicking sound to indicate that pairing was successful.
Press the ON button to turn on and the OFF button to turn off the connected
remote socket, the LED indicator on the remote control lights up when a
command is sent. The LED light on the remote control lingers for a short
while before it is ready to send a new command, wait for it to turn off before
you send a new command to the remote socket. Several receivers can be
connected to the same channel, follow the pairing instructions and add more
remote sockets to the same channel.
Pair with smart home controller (sold separately):
Search for nearby devices in the smart home controller interface within
30 seconds. Add the remote socket when it is found in the controller. The
indicator on the remote socket turns solid red and emits a clicking sound to
indicate that pairing was successful to your controller.
Resetting
Unplug and reconnect the remote socket into a wall socket. Press the OFF
button on the paired remote control or smart home controller within 30
seconds. The LED-indicator on the remote socket starts flashing to indicate
the reset was completed and that it is ready to pair with another remote
control, channel or controller. Remove the connection to the remote socket in
the smart home-controller interface.
Safety information
Only for use in wall sockets, do not connect to an extension cord.
Do not stack wireless remote sockets on each other or use two receivers in
proximity.
Not suited for equipment that needs constant supervising due to a risk of fire
such as a flat iron.
Suitable for working temperatures from -20°C and up.
Do not open or modify the devices in any way, this should only be carried out
by a qualified technician due to the risk of electric shocks or short circuit.
The remote has an approximate range of 25 m, this range can vary greatly due
to concrete walls, electrical or electromagnetic sources that can interfere with
the signal.
Disconnect the sockets completely to assure there is no voltage output. Only
for use in dry areas.
Note! If you encounter any problems with the manual, please go to
www.kjell.com/50990 for an updated version.
Simplified EU Declaration of Conformity
Kjell & Company hereby declares that this device is in compliance with the
essential requirements and other relevant provisions of Directive 2014/53/
EU. Full text of the EU declaration of conformity is available at www.kjell.
com/50990.
Specifications
Frequency: 433.92 MHz
Range: Up to 25 metres
Max. load: 3000 W
IP rating IP44
Memory slots: 6
Effective Radiated Power: -5.30 dBm
To Next Page
Loading...