8
OPERATION INSTRUCTIONS
1. Remove the lid by lifting the leather tag.
2. Take out the water tank.
3. Turn the water tank upside down
and unscrew the water tank cover
(turn it anti-clockwise) and fill
water tank with clean water.
NOTE
Use only clean, cool tap water to fill the water
tank. Do not use hot water. Filtered or distilled
water is recommended to avoid scale build up
if tap water is too hard.
4. Replace the water tank cover. Turn the
water tank back up the right way and
place into the unit. Place the lid back on.
5. Locate a flat, stable location and plug
the power cord into the appropriate
electrical outlet. The Power indicator
light will illuminate red.
6. Switch on the unit by pressing the POWER
button . The Power indicator light will
illuminate blue and the unit will begin to
work on default setting (MIN mist level).
7. To select MIST LEVEL: Press the Mist
level button to select between MAX
(maximum) and MIN (minimum).
8. When water level in the water tank is
low, the unit will automatically stop
operation and power indicator light will
flash red. Follow steps 1-4 to continue.
9. Light Option: Push the Light
Button to switch on/off the light
located underneath the unit.
PRODUCT SPECIFICATIONS ULTRASONIC HUMIDIFICATION SYSTEM
MODEL CODE CLI-AH201
POWER SUPPLY 20W
POWER CONSUMPTION 2.5 Litres
WATER TANK CAPACITY 150ml/h
EVAPORATION RATE Up to 20m
NOISE LEVEL 10 Hours
Functions
To Next Page
Loading...