10
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | tempo.org/support
Oscillation control
• To switch on the oscillation feature, press the [ I ] side of the oscillation
control switch, located at the base of the appliance.
• To switch off the oscillation feature, press the [ O ] side of the oscillation
control switch located at the base of the appliance.
Operating Instructions (Cont.)
Setting the thermostat
• After the heater has been switched on and the room as reached the desired
temperature, slowly rotate the thermostat knob counter-clockwise until the
heater shuts off (there will be a faint “click” sound).
• By turning the thermostat at this setting, the temperature will be
automatically maintained.
• To lower the temperature, turn the knob counter-clockwise (towards the
minimum position).
• To raise the temperature, turn the knob clockwise (towards the maximum
position).
Fan-only mode
• To switch on the fan-only operating mode, turn the ON/OFF/Power Level
dial to the fan [ ] setting.
• Turn the thermostat knob fully clockwise so that the fan will run
continuously.
To Next Page
