What to do if my Clihome Indoor Fireplace turns off and won't turn back on?
If your Clihome Indoor Fireplace turns off and won't turn back on, it may have overheated, causing the thermal switch to disconnect, or the home circuit breaker may have opened. To resolve this, turn off the main power, wait, and then turn it back on. Alternatively, check and reset the circuit breaker.
Why is the flame not visible on my Clihome IF-72FSB Indoor Fireplace?
If the flame is not visible on your Clihome Indoor Fireplace, ensure the flame is set to high by pushing the flame button. Also, disconnect the fireplace from the power source and inspect the wiring for any loose connections. Repair or replace the wiring if necessary.
How to fix a flame that is not moving on my Clihome IF-72FSB?
If the flame is not moving in your Clihome Indoor Fireplace, you should inspect the wiring for loose connections. If the wiring is secure, the flame motor may be defective, and you should call a qualified service technician to replace it. Another potential issue is that the flame rod may be out of place; to fix this, remove the glass, flip the fireplace upside down, remove the screws holding the bottom frame plate, and place the flame rod back into position.
What to do if Clihome Indoor Fireplace remote control does not work?
If the remote control for your Clihome Indoor Fireplace isn't working, first, try replacing the batteries. Ensure you're aiming the remote at the sensor located directly behind the glass screen, just above the logs, in the center of the unit. If it still doesn't work, you may need to replace the remote control or the sensor.
Why does my Clihome Indoor Fireplace turn off and will not turn on?
If your Clihome Indoor Fireplace turns off and won't turn back on, it may have overheated. This can cause the thermal switch to disconnect or the home circuit breaker to open. To fix this, turn off the main power switch, wait, and then turn it back on. Alternatively, check and reset the circuit breaker.
What to do if flame is not visible on Clihome IF-72FSB?
If the flame is not visible in your Clihome Indoor Fireplace, there could be a couple of reasons. First, check the wiring; if it's loose, disconnect the fireplace from the power source and inspect the wiring for loose connections, repairing or replacing as needed. Also, ensure that the flame is set to high by pushing the flame button.
How to fix flame not moving on Clihome IF-72FSB Indoor Fireplace?
If the flame in your Clihome Indoor Fireplace isn't moving, start by inspecting the wiring for any loose connections. If the wiring is secure, the flame motor might be defective, requiring a qualified service technician to replace it. Also, the flame rod might be out of place. This can be corrected as simple as removing the glass, flipping the fireplace upside and down, removing a set of screws that are holding the bottom frame plate and placing the flame rod back into place.
Why is log set and/or ember not glowing on Clihome IF-72FSB Indoor Fireplace?
If the log set and/or ember in your Clihome Indoor Fireplace isn't glowing, first, disconnect the fireplace from the power source and inspect the wiring for loose connections, repairing or replacing if necessary. Also, ensure that the ember is not off mode.
General| Brand | Clihome |
|---|---|
| Model | IF-72FSB |
| Category | Indoor Fireplace |
| Language | English |
To Next Page
