• It is recommended that the appliance be allowed to settle for at least 24 hours before
connecting the electrical power supply, so that the compressor fluid feed is correct.
• Proper air circulation is necessary to avoid overheating. To ensure sufficient ventilation,
observe the installation recommendations provided.
• In order to avoid fire risk, wherever possible, ensure that the appliance is not in contact
with walls or with any hot element (compressor, condenser). Observe the installation
recommendations.
• The appliance should not be placed close to radiators or cooking hot plates or gas
rings.
• Check that electrical sockets remain accessible when the appliance is installed.
• When positioning the appliance, ensure the supply cord is not trapped or damaged.
Power saving
To limit the electricity consumption of your appliance:
✓ Install it in an appropriate place (see “Installation instructions”).
✓ Leave the doors open as little time as possible.
✓ To ensure that the appliance operates properly, clean the condenser regularly (see
“Maintenance”).
✓ Regularly inspect the door seals and ensure that they are still closing properly. If
this is not the case, contact your after-sales service.
✓ The following combination of shelves is recommended for energy to be used as
efficiently as possible by the refrigeration unit. There are four shelves and one
display shelf in total.
✓ The appliance's thermostat is electronic and allows you to set the temperature
between 5 and 20 degrees.
To Next Page
Loading...
