5. OPERATING INSTRUCTIONS
It is recommended that you installed your appliance in a place where the ambient temperature is
between 10-32°C. If the ambient temperature is above or below recommended temperatures, the
performance of the unit may be affected and it may not be possible to obtain temperature between 5-20°C.
Control panel
• “LIGHT” Button
Lighting control button
• “POWER” Button
On/Off switch
• “DISPLAY”
Electronic temperature display
• “UP” Button
+ Temperature setting button.
• “DOWN” Button
- Temperature setting button.
• “°C/°F” Button
- Reverse °C to °F. - press light button for 3 seconds
• “LOCK” Button
- Control panel unlock button - press UP button for 3 seconds to unlock the control panel..
• You can choose the desired chamber temperature by using the “+ / -”. buttons. The temperature
selected increases/decreases by 1°C with each button press.
• The temperature can be chosen between 5 and 20°C.
• If the appliance runs after a power failure, the previous set temperature does also exist as the control
panel has the memory function.
When the surrounding temperature is 25°C and the wine cooler has no bottle loaded, it will take
around 30 minutes to increase the wine cooler’s temperature from 5°C to 12°C. Under the same
circumstance, it will take around one hour to decrease the wine cooler’s temperature from 12°C to
5°C. The less the temperature span is, the less time it will take. The setting temperature of upper
zone should be lower than the setting temperature of lower zone
To Next Page
Loading...
Need help?
General
