IMPORTANT:
If the power cable supplied is damaged, it must be replaced by the manufacturer, a service centre approved by
the brand or the retailer. In all events, it must be replaced by qualified personnel in order to avoid any risk of
injury.
IF THESE CHECKS REVEAL NOTHING, THEN CONTACT YOUR RETAILER’S AFTER-SALES DEPARTMENT.
CAUTION!
Unplug the appliance before carrying out any maintenance or repair work.
12° PROBLEMS AND SOLUTIONS
You can solve many simple problems with your wine cellar yourself, thus avoiding having to contact your after-
sales department. Try the following suggestions.
The cellar will not start.
The cellar is not plugged in.
The on/off button is in the off position.
The fuse in your electrical installation has blown.
The cellar does not cool sufficiently.
Check the temperature selected.
The external temperature is beyond the cellar’s operating
temperature.
The cellar is opened too often.
The door is not properly closed.
The door seal is not sealing correctly.
The compressor starts and stops frequently.
The external temperature is high.
A large quantity of bottles has been put into the cellar.
The cellar is opened frequently.
The door is not properly closed.
The cellar has not been correctly set.
The door seal is not sealing correctly.
The light does not operate.
The cellar is not plugged in.
The fuse in your electrical installation has blown.
The LED is not working.
Check and ensure that the cellar is level.
The cellar makes a lot of noise.
A noise resembling circulating water is produced by the
coolant gas and this is normal.
At the end of a cooling cycle, you can hear the noise of water
circulating.
Expansion and contraction of the internal walls may cause a
cracking sound.
The door does not close correctly.
The cellar is not level.
The door seal is dirty or damaged.
The shelves are not positioned correctly.
A part of the contents is preventing the door from closing.
Sensor problem, contact your retailer’s after sales department
To Next Page
Loading...
Need help?
General
