49
CAUTIONS:
⚫
The air conditioner will not operate if curtains, doors or other materials block the signals from
the remote controller to the indoor unit.
⚫
Prevent any liquid from falling into the remote controller. Do not expose the remote controller
to direct sunlight or heat.
⚫
If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air
conditioner may not function properly. Use curtains to prevent the sunlight from falling on the
receiver.
⚫
If other electrical appliances react to the remote controller, either move these appliances or
consult your local dealer.
Replacing batteries
The remote controller is powed by two dry batteries(R03/LR03X2) housed
in the rear part and protected by a cover.
1. Remove the cover by pressing and sliding off.
2. Remove the old batteries and insert the new batteries,placing the(+) and
(-) ends correctly.
3. Reattach the cover by sliding it back into position.
NOTE: When the batteries are removed, the remote controller erases all
programming. After inserting new batteries, the remote controller must be
reprogrammed.
CAUTIONS:
⚫
Do not mix old and new batteries or batteries of a different type.
⚫
Do not leave the batteries in the remote controller if it is not going to be used for 2 or 3
months.
⚫
Dispose of the old batteries in the special containers to be found in the sales outlets.
Remote controller specifications:
To Next Page
Loading...
Need help?
General
