52
button again when you want to cancel the lock mode. A lock symbol will appear on the remote control display as
soon as the lock function is activated.
14.
Turbo Button (Optional)
Press this button to activate the turbo mode, in air conditioner or heating mode, the speed will be at maximum
and the parameters will be restored after 20 min of turbo mode.
15.
LED DISPLAY Button
Press this button to turn off the display on the air conditioner. Press again to turn on the display on the
air conditioner.
Drainage opération
✓ When the air conditioner is in dehumidifier mode (dry) remove the drain plug on the back of the
unit, install the drain connector (universal 5 / 8˝ female connector) with a 3/4 ˝ pipe (purchased
locally).
NOTE: Make sure the hose is secure so there is no leakage. Point the pipe to the drain, making sure
there are no kinks that can prevent water flow. Place the end of the hose in the discharge hose and
make sure the end of the hose is down to allow the flow of water to flow smoothly. When the continuous
drain hose is not in use, make sure that the drain plug and knob are properly installed to prevent
leakage.Lorsque « P1 » s’affiche sur l’écran cela signifie que le réservoir d’eau inférieur est plein, le
climatiseur s’arrête alors de fonctionner. Cependant, le moteur du ventilateur continuera à fonctionner
(ceci est normal).
To Next Page
Loading...
Need help?
General
