Ambient room temperature limits
This appliance is designed to operate in ambient temperatures specified by its temperature
class marked on the rating plate.
This refrigerating appliance is intended to be used at ambient temperatures ranging
from 10 °C to 32 °C
Installing your wine cellar
• This unit is intended for free-standing installation only. It must never be built-under or
built-in. For proper operation of the appliance, it is imperative to allow good air
circulation around the unit. We do not accept any liability instance of non-compliance with
the installation instructions.
• Position it in a place with sufficient strength to support its weight when loaded.
• To get the best from your appliance with the lowest energy consumption, do not place the
appliance close to a heat source (heater, cooker, etc.), do not expose it to direct sunlight,
and do not place it in a room which is too cold.
• Plug the cellar into a single outlet.
• Screw the stopper supplied inside the wine cellar to maintain a 10 cm minimum distance
between the back of the cellar and the wall in front of it is placed. Ensure that your wine
cellar is perfectly horizontal, then slightly raise the two front feet (use of a spirit level is
recommended). This will prevent any movement due to instability, causing noise and
vibration, and will ensure that the door seals perfectly.
To Next Page
Loading...
Need help?
General
